How To Install Vinyl Windshield Banner

Windshield Imprint Installation

To install your Spinnywhoosh banner start by placing the imprint on your windshield perfectly even. Place ii small pieces of record on both left and right sides to concur information technology up and one longer strip of tape downwardly the center coming off the top and bottom of your imprint, this will human activity as a hinge.

Pull one side of the banner upward to the hinge and peel downwardly the paper bankroll, leaving the vinyl banner material stuck to the transfer tap. Cut the backing paper off at the hinge. Spray the back of the now exposed adhesive backing of the imprint and windshield. Do not get the paper backing from the other side moisture.

Take a squeegee(credit card will as well piece of work) and slowly lay the banner downwards, squeegeeing out the water as y'all go until the outset side is completely laid and chimera costless.

Next practice the same to the other side. Remove the eye record, discard remaining paper backing, spray, squeegee! Once both sides have been laid, slowly peel back the transfer tape from the banner.

NOTES

It is easiest to utilise banners to a warm windshield over common cold. If possible, moderately heat with a heat gun. However do non over heat.
Beware of heavy wind when installing.
Specialty materials such as oilslick, sparkle, etc should be applied dry out.
Clean windshield thoroughly with water or alcohol, Exercise Non use RainX or other polishes.

INSTALLATION VIDEO

INSTALLATION PHOTOS

Here are some quick photos shot while installing some banners on race official'south trucks while out doing some vinyl installation with Redline Design. These photos show the process of a dry out install(Not using water or awarding fluid) and the entire procedure was photographed in a matter of minutes.

ane) Marshal Imprint to pinnacle of windshield. For sunvisor banners you lot may move the imprint upward higher if y'all'd like and trim excess once finished.

2) Place long piece of tape in center of banner to act as hinge and carefully pull upwardly imprint vinyl off backing paper

3) Cutting backing newspaper at hinge and discard.

4) Brainstorm to squeegee down the banner onto the drinking glass. If you lot wish, you may use application fluid at this step, making sure not to get other side of newspaper backing wet.